Wednesday, January 30, 2008

Improved Bottle of Hope Stopper

The problem with stoppers like these is that clay does not stick to them well. Also, they tend to fall out if a heavy top is placed on them. Here is a method to make them work a little better. It sounds complicated, but it really is quite fast.

Get a leather punch, a hammer and a small block of wood. My “Maxi” leather punch set came from Michaels and I use the largest tip with it. (You will punch a hole in the stopper and you want it to be as large as possible. The Mini punch set is too small.)

Place the piece of wood on the floor or a very sturdy table; place the stopper on the wood with the top of the stopper down; center the punch in the inner ring of the stopper and whack it a couple of times with the hammer.
Roll out a snake of clay about the diameter of the inner ring of the stopper. Taper one end so that it is small enough to fit through the hole in the stopper. Insert the narrow end of the clay through the stopper from bottom to top.




While holding the clay firmly in the stopper, mash down the narrow part on top. You can spread it out as wide as you want. Just don’t disturb the core of clay going through the hole. Trim the bottom part of the clay to about 1/4 inch. Make sure the bottom part of the clay is the same diameter as the inner ring of the stopper. Insert it into the bottle to make sure it will fit, but DO NOT put the stopper all the way in. If you do, you will tear the inner clay core when you try to take it out for baking.

You can stop here, but you can make one additional enhancement if you wish. Use a needle tool to make a channel around the bottom part of the clay. After the stopper is baked, place a tiny rubber band in the channel so it will act as an O-ring. You will have to wrap the rubber band twice to make it tight. The tiny rubber bands can be found in a dollar store in the hair accessory section. You will have to experiment a bit to find the proper size for the channel.

You can bake before decorating the top or after. The clay you put on top will now be anchored to the stopper by the core of clay going through the center. If you bake before decorating, use liquid clay to make the new clay stick to the button on top.

Let the stopper cool thoroughly before trying to insert it into a bottle. If the clay is warm, you can tear the inner core by trying to pull it out.

1 comment:

iggy said...

hi cynthia
i tried cutting the inner part off these tops and it worked well also, but as you said they are fragile while warm! i like your idea of keeping the top whole, but i also took my tiny drill bit, drilled right thru all after baking and then super glued a tiny toothpick up thru just for more support. sometimes i make a totally clay stopper and i also do the groove and tiny rubber band trick.works a charm.....

georgia